by Mike Haney
In this photo, I’m using the Intel heat sink/fan unit instead of the Zalman. Funny story: I installed the Zalman first only to find that it only had a three-pin connector and the socket had four pins. Too lazy to actually look at the Intel directions, I freaked out, pulled it off and used the Intel HSF instead. Only when the build was done and I was cleaning up did I notice that I could use the three-pin connector and just skip a pin, so I ripped everything back out and installed the Zalman instead. You can also see here the cables from the unused included front ports and the 3.5-inch bays lying outside the case.